looks good On Wed, Sep 8, 2010 at 9:25 AM, Igor Chudov <[email protected]> wrote:
> Got it. > > Do in MDI: > > M6 T2 G43 > (then set height using a sliding gage block) > (then set Z=zero) > (then start program that again asks for T2.) > > - Igor > > > > On Wed, Sep 8, 2010 at 9:20 AM, Stuart Stevenson <[email protected]> > wrote: > > the g43 is the important part > > you need to turn on the tool length offset for the tool in the spindle > and > > then the tool will be able to set the work piece coordinate zero > > > > > > On Wed, Sep 8, 2010 at 8:26 AM, Andy Pugh <[email protected]> > wrote: > > > >> On 8 September 2010 14:20, Igor Chudov <[email protected]> wrote: > >> > > >> > Should I select my first tool in MDI > >> > (say M6T2), > >> > >> Don't forget the G43... > >> > >> -- > >> atp > >> > >> > >> > ------------------------------------------------------------------------------ > >> This SF.net Dev2Dev email is sponsored by: > >> > >> Show off your parallel programming skills. > >> Enter the Intel(R) Threading Challenge 2010. > >> http://p.sf.net/sfu/intel-thread-sfd > >> _______________________________________________ > >> Emc-users mailing list > >> [email protected] > >> https://lists.sourceforge.net/lists/listinfo/emc-users > >> > > > > > > > > -- > > dos centavos > > > ------------------------------------------------------------------------------ > > This SF.net Dev2Dev email is sponsored by: > > > > Show off your parallel programming skills. > > Enter the Intel(R) Threading Challenge 2010. > > http://p.sf.net/sfu/intel-thread-sfd > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > > ------------------------------------------------------------------------------ > This SF.net Dev2Dev email is sponsored by: > > Show off your parallel programming skills. > Enter the Intel(R) Threading Challenge 2010. > http://p.sf.net/sfu/intel-thread-sfd > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- dos centavos ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
