the g43 is the important part you need to turn on the tool length offset for the tool in the spindle and then the tool will be able to set the work piece coordinate zero
On Wed, Sep 8, 2010 at 8:26 AM, Andy Pugh <[email protected]> wrote: > On 8 September 2010 14:20, Igor Chudov <[email protected]> wrote: > > > > Should I select my first tool in MDI > > (say M6T2), > > Don't forget the G43... > > -- > atp > > > ------------------------------------------------------------------------------ > This SF.net Dev2Dev email is sponsored by: > > Show off your parallel programming skills. > Enter the Intel(R) Threading Challenge 2010. > http://p.sf.net/sfu/intel-thread-sfd > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- dos centavos ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
