Got it. Do in MDI:
M6 T2 G43 (then set height using a sliding gage block) (then set Z=zero) (then start program that again asks for T2.) - Igor On Wed, Sep 8, 2010 at 9:20 AM, Stuart Stevenson <stus...@gmail.com> wrote: > the g43 is the important part > you need to turn on the tool length offset for the tool in the spindle and > then the tool will be able to set the work piece coordinate zero > > > On Wed, Sep 8, 2010 at 8:26 AM, Andy Pugh <a...@andypugh.fsnet.co.uk> wrote: > >> On 8 September 2010 14:20, Igor Chudov <ichu...@gmail.com> wrote: >> > >> > Should I select my first tool in MDI >> > (say M6T2), >> >> Don't forget the G43... >> >> -- >> atp >> >> >> ------------------------------------------------------------------------------ >> This SF.net Dev2Dev email is sponsored by: >> >> Show off your parallel programming skills. >> Enter the Intel(R) Threading Challenge 2010. >> http://p.sf.net/sfu/intel-thread-sfd >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > > > -- > dos centavos > ------------------------------------------------------------------------------ > This SF.net Dev2Dev email is sponsored by: > > Show off your parallel programming skills. > Enter the Intel(R) Threading Challenge 2010. > http://p.sf.net/sfu/intel-thread-sfd > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ This SF.net Dev2Dev email is sponsored by: Show off your parallel programming skills. Enter the Intel(R) Threading Challenge 2010. http://p.sf.net/sfu/intel-thread-sfd _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users