Il 22/11/2010 15:40, Andy Pugh ha scritto: > On 22 November 2010 14:23, Spiderdab<[email protected]> wrote: > > >> my stepper motors are these: >> http://www.goodluckbuy.com/nema-23-stepper-motor-12-6kgcm-1-8degre-4leads-56mm-57bygh56-401a.html >> > Those are quite short steppers, there are some about twice as long > with about twice the torque, > > >> so, supposing to use my steppers and changing only the drive, how much >> voltage do you think can i apply to these? >> > The motors have a dielectric strength quoted of 500V AC for one > minute. They should work fine at 100V. The limiting factor is likely > to be the stepper drive. > The stepper drive will limit the current to the set value, so > steady-state the voltage across the motor will be exactly the same as > it is now (about 2.5V). The advantage is that when the motor is > spinning rapidly it can still supply the same current with a 50V > back-emf. > > >> Than i'm interested in learning how to use servos and closed loop, so >> i'm reading much on discussions about this. that's why people are asking >> me to use this system to move a camera of about 20-30kg. so i'll need a >> more serius/powerful/precise system.. i'm going to ask about in a later >> moment. >> > That's a much more serious proposition, and will need real money. > Probably around EUR1000 per motor (for a 20Nm 400V AC servo). For > drives the Mesa 8i20 might be an option, though support in EMC2 is > still rather experimental. > > ...and what about the 7i29? i could use two of them for a 4 motors system..
------------------------------------------------------------------------------ Beautiful is writing same markup. Internet Explorer 9 supports standards for HTML5, CSS3, SVG 1.1, ECMAScript5, and DOM L2 & L3. Spend less time writing and rewriting code and more time creating great experiences on the web. Be a part of the beta today http://p.sf.net/sfu/msIE9-sfdev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
