Hi - 

I got an old CNC router (phoenix) from a school district auction and am very 
eager to get it going.
The old interface is using a serial cable and I need figure out how to connect 
this to EMC.
The electronics part is where I am a bit rusty - sorry if I ask obvious 
questions.

Here is the low down:

Drivers:    IB106 (see http://www.forsalesticker.com/drivers.jpg)
Steppers:   1.8 deg - Eastern Air Devices  LA34BJK-P500


How do I know what numbers to put on the driver timing settings on the first 
screen of stepConf? (see http://www.forsalesticker.com/StepConf1.png)
How do I determine the following on the axis configuration: (see 
http://www.forsalesticker.com/StepConf1.png)
'Motor steps per revolution'
'Driver microstepping'
'leadscrew pitch' (do I just count the number of threads per inch?)


I am guessing that I bypass this board completely (see 
http://www.forsalesticker.com/bboard.jpg)


Any advice will be much appriciated.

Thanks

Andy

------------------------------------------------------------------------------
All of the data generated in your IT infrastructure is seriously valuable.
Why? It contains a definitive record of application performance, security 
threats, fraudulent activity, and more. Splunk takes this data and makes 
sense of it. IT sense. And common sense.
http://p.sf.net/sfu/splunk-d2d-c2
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to