Sorry for top replying. They are step/dir, so you can get rid of the interface board. Here is a data sheet http://www.servo-systems.com/pdf/ib10x_091803.pdf Pretty sure they just use a common L298 driver. No micro-stepping. 1.8 degrees per step is 200 in full step/400 in half step. Pitch is how many threads per inch. Eric
On Mon, Jun 27, 2011 at 4:41 PM, For Sale Sticker <e...@forsalesticker.com> wrote: > Hi - > > I got an old CNC router (phoenix) from a school district auction and am very > eager to get it going. > The old interface is using a serial cable and I need figure out how to > connect this to EMC. > The electronics part is where I am a bit rusty - sorry if I ask obvious > questions. > > Here is the low down: > > Drivers: IB106 (see http://www.forsalesticker.com/drivers.jpg) > Steppers: 1.8 deg - Eastern Air Devices LA34BJK-P500 > > > How do I know what numbers to put on the driver timing settings on the first > screen of stepConf? (see http://www.forsalesticker.com/StepConf1.png) > How do I determine the following on the axis configuration: (see > http://www.forsalesticker.com/StepConf1.png) > 'Motor steps per revolution' > 'Driver microstepping' > 'leadscrew pitch' (do I just count the number of threads per inch?) > > > I am guessing that I bypass this board completely (see > http://www.forsalesticker.com/bboard.jpg) > > > Any advice will be much appriciated. > > Thanks > > Andy ------------------------------------------------------------------------------ All of the data generated in your IT infrastructure is seriously valuable. Why? It contains a definitive record of application performance, security threats, fraudulent activity, and more. Splunk takes this data and makes sense of it. IT sense. And common sense. http://p.sf.net/sfu/splunk-d2d-c2 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
