>The cuttoff slide was air over hydrolic to make it move smoother, just?get rid of it >and use a cut off for a lathe that way you can put a little chamfer on the >OD before you part off.
I will do that. >Collet closer is air.Hope you have the solenoids for it because they keep >the collet closed after the air is released.There is alot of o-rings inside the >closer so if the machine has been sitting for a while start putting a few drops >of air tool oil down the tubes on the closer every day till you are done with >the rest of the machine. Also good advice. I have not tested the closer yet so I will start getting oil in it today. >My spindle motor is 5 hp but 3 would be ok if your diameters dont get too big >and feedrates stay conservative. I don't have a motor yet so I will go with a 5HP... definitely rules out my servo. Mike ------------------------------------------------------------------------------ For Developers, A Lot Can Happen In A Second. Boundary is the first to Know...and Tell You. Monitor Your Applications in Ultra-Fine Resolution. Try it FREE! http://p.sf.net/sfu/Boundary-d2dvs2 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users