2013/6/26 Gregg Eshelman <[email protected]> > On Tue, 6/25/13, Alex Joni <[email protected]> wrote: > > Subject: Re: [Emc-users] Why doesn't LinuxCNC run? Error log attached. > To: "Enhanced Machine Controller (EMC)" <[email protected]> > Date: Tuesday, June 25, 2013, 1:47 AM > > The error is in your log: > > [ 216.183331] RTAI[hal]: ERROR, LOCAL APIC CONFIGURED > BUT NOT > AVAILABLE/ENABLED. > > and a good description (including a fix) can be found here: > > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?TroubleShooting#emc2_doesn_t_run_missing_lapic > > Regards, > Alex > > Well that might fix it, if I knew how to change it from read only so it > can be edited. Were this Windows I could run a text editor with elevated > Administrator rights, make the change, save it then it goes back to its > usual untouchable setting. >
If I understand correctly, what you are asking, then opening a text editor with root privileges is very simple - in terminal execute "sudo gedit". -- Viesturs If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ This SF.net email is sponsored by Windows: Build for Windows Store. http://p.sf.net/sfu/windows-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
