Andy, You talking about doing it this way? http://buildbot.linuxcnc.org/ (BTW, I found that by googling "how to get linuxcnc master branch")
Agreed. Doing git and compiling falls under "linux guru". But even I can follow the above instructions. On Thu, Apr 3, 2014 at 4:01 PM, andy pugh <bodge...@gmail.com> wrote: > On 3 April 2014 20:31, Marius Liebenberg <mar...@mastercut.co.za> wrote: > > Mark > > Use the git method to install and compile the master branch. > > I do think that falls into the "Linux Guru" category though. > > Setting up an alternative software source (which I haven't found any > problems with) is only a small extension of the normal way of getting > software. > > -- > atp > If you can't fix it, you don't own it. > http://www.ifixit.com/Manifesto > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users