On 8/12/14 9:04 AM, Marius Liebenberg wrote: > I connected my spindle cmd signal to an abs component. When I set the > speed for any output positive or negative, I get absolutely no output. > Nor does any of the polarity indicators function. > The setup uses a 5i25 with a 7i76 so I had to load EMCMOT with the base > thread enabled as the abs component takes a float for input and output. > Any ideas?
Hard to tell without seeing your hal config. Did you addf the abs function to the proper place in the proper thread? -- Sebastian Kuzminsky ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
