Its loaded, but, it's never going to work without being tied to a thread. On 08/12/2014 11:14 AM, Marius Liebenberg wrote: > On 2014-08-12 17:08, Sebastian Kuzminsky wrote: >> On 8/12/14 9:04 AM, Marius Liebenberg wrote: >>> I connected my spindle cmd signal to an abs component. When I set the >>> speed for any output positive or negative, I get absolutely no output. >>> Nor does any of the polarity indicators function. >>> The setup uses a 5i25 with a 7i76 so I had to load EMCMOT with the base >>> thread enabled as the abs component takes a float for input and output. >>> Any ideas? >> Hard to tell without seeing your hal config. > Very straight forward connection in and out. >> Did you addf the abs function to the proper place in the proper thread? >> > I get an error if I do addf so I left it out. I can see the function in > the list of halshow though. Does that mean it is not loaded properly? > >
-- Billy Huddleston Inner Vision *William Huddleston Inner Vision Development Corp* Office: 865.560.2752 Fax: 865.560.2703 http://www.ivdc.com *Development and Consulting... Simplified.* <http://www.facebook.com/pages/Inner-Vision-Development/120023721424> <http://twitter.com/ivdc> <http://www.linkedin.com/in/ivdccorp> ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
