On 2014-08-12 17:13, Philipp Burch wrote: > Hi Marius! > > On 12.08.2014 17:04, Marius Liebenberg wrote: >> I connected my spindle cmd signal to an abs component. When I set the >> speed for any output positive or negative, I get absolutely no output. >> Nor does any of the polarity indicators function. >> The setup uses a 5i25 with a 7i76 so I had to load EMCMOT with the base >> thread enabled as the abs component takes a float for input and output. >> Any ideas? >> > Just a thought: Does the abs component use floating point math, while > your base thread does not support that? Yes blonde moment there. The servo thread is floating point not base-thread. :( I first used abs_s32 and then changed to abs without changing the thread.
> Regards, > Philipp > > > > ------------------------------------------------------------------------------ > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 QQ 1767394877 ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users