Isn't there a abs pin already integrated into the spindle cmd so you don't have to use the abs component now?
On 08/12/2014 11:08 AM, Sebastian Kuzminsky wrote: > On 8/12/14 9:04 AM, Marius Liebenberg wrote: >> I connected my spindle cmd signal to an abs component. When I set the >> speed for any output positive or negative, I get absolutely no output. >> Nor does any of the polarity indicators function. >> The setup uses a 5i25 with a 7i76 so I had to load EMCMOT with the base >> thread enabled as the abs component takes a float for input and output. >> Any ideas? > Hard to tell without seeing your hal config. > > Did you addf the abs function to the proper place in the proper thread? > > -- Billy Huddleston Inner Vision *William Huddleston Inner Vision Development Corp* Office: 865.560.2752 Fax: 865.560.2703 http://www.ivdc.com *Development and Consulting... Simplified.* <http://www.facebook.com/pages/Inner-Vision-Development/120023721424> <http://twitter.com/ivdc> <http://www.linkedin.com/in/ivdccorp> ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
