On Thu, 18 Sep 2014, [email protected] wrote:
> Date: Thu, 18 Sep 2014 16:52:05 -0500
> From: [email protected]
> Reply-To: "Enhanced Machine Controller (EMC)"
> <[email protected]>
> To: [email protected]
> Subject: Re: [Emc-users] New to LinuxCNC and PnCConf and need some help...
>
> Ok, that red herring has been fried. I went through the troubleshooting
> steps and disabled essentially everything disableable in the BIOS. Now the
> "unexpected realtime delay" is gone and the latency test also is producing
> better numbers, now ~14000.
>
> The original spindle issue remains, no operation at all from within
> linuxCNC, despite normal operation from the PnCConf test. :(
>
> Thanks,
>
> Pete C.
>
I would now try John Kasunich's suggestion of posting the good (pncconf
running open loop test) and bad (linuxcnc running) dumps of all hal data on
pastebin or a similar site
>
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
Slashdot TV. Video for Nerds. Stuff that Matters.
http://pubads.g.doubleclick.net/gampad/clk?id=160591471&iu=/4140/ostg.clktrk
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
