<expletive deleted> I added the missing rpm in the hal config,
>From this: net spindle-vel-cmd-abs => hm2_5i25.0.7i76.0.0.spinout To this: net spindle-vel-cmd-rpm-abs => hm2_5i25.0.7i76.0.0.spinout And now the spindle runs in linuxCNC. There is still an issue since it seems doing an S setting in MDI isn't changing the speed. I'm getting full speed in MDI m03/m04 regardless of my s command. In the manual tab, if I click the spindle run button I'm either getting full speed, or clicking the - button will drop it to a crawl, probably 1V control voltage. I guess this is progress... ------Original Mail------ From: <[email protected]> To: <[email protected]> Sent: Thu, 18 Sep 2014 17:49:38 -0500 Subject: Re: [Emc-users] New to LinuxCNC and PnCConf and need some help... That gets back to my earlier post where there seems to be some mismatch in naming. If others are using 2.6.3 though I would expect if it was an issue it would have been found some time ago? This is what PnCConf created, not anything I modified. Searching the halcmd show I find: float OUT 10 motion.spindle-speed-out-abs ==> spindle-vel-cmd-rpm-abs float 0 spindle-vel-cmd-abs ==> hm2_5i25.0.7i76.0.0.spinout I find no connection between spindle-vel-cmd-rpm-abs which shows 10 (full speed) and spindle-vel-cmd-abs which shows zero. Is it as simple as rpm missing in the nameing? ------Original Mail------ From: "andy pugh" <[email protected]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Thu, 18 Sep 2014 23:39:16 +0100 Subject: Re: [Emc-users] New to LinuxCNC and PnCConf and need some help... On 18 September 2014 22:52, <[email protected]> wrote: > The original spindle issue remains, no operation at all from within linuxCNC, > despite normal operation from the PnCConf test. :( Is there a value on the motion.spindle-speed-abs pin? Is that value finding its way to the attached signal, and is that value making its way to 5i25....spinout ? -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that Matters. http://pubads.g.doubleclick.net/gampad/clk?id=160591471&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that Matters. http://pubads.g.doubleclick.net/gampad/clk?id=160591471&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that Matters. http://pubads.g.doubleclick.net/gampad/clk?id=160591471&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
