On 11 May 2015 at 03:18, Gene Heskett <ghesk...@wdtv.com> wrote: > But now I am back to the G7/G8 diffs which are costing me money
I don't think that anything has changed there. But youmay be seeing differences related to starting from scratch. (I don't _know_ that nothing has changed, but I can't see any reason that it would) What you have seen is probably related to touching off a diameter in radius mode, then moving to a diameter in diameter mode. (Imagine the tool is at a radius of 25mm and a diameter of 50, you are in radius mode, touch off 50mm, the machine assumes you mean 50mm radius / 100mm Dia. When you switch to Diameter mode and G0 X50 the machine _thinks_ it is at 100mm dia so plunges 25mm inwards to what is actually 0mm dia) Do you use a "reference tool" or do all tools have an offset? I seem to recall you use some form of touch-off plate. I think you might need to do some tool-changing, jogging about and switching between modes to see where you are (and also check the tool table entries). The "exceeds limits" thing can probably be cleared by touching off again to the right diameter in the right mode. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ One dashboard for servers and applications across Physical-Virtual-Cloud Widest out-of-the-box monitoring support with 50+ applications Performance metrics, stats and reports that give you Actionable Insights Deep dive visibility with transaction tracing using APM Insight. http://ad.doubleclick.net/ddm/clk/290420510;117567292;y _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
