On Wed, Jun 17, 2015 at 9:46 PM, Gene Heskett <[email protected]> wrote:
> 5 each 4mmx.70x20mm black hi-tensile allen head cap screws. > > One coupling is missing its clamp screw, and one motor mount is missing > the mount screws for the Y motor. Box of 100, with ship, a few cents > above a $20 bill. Heck, I burnt more gas than that touring 2 counties > here without finding them, so I can't fuss too loud, nobody would listen > anyway. > > I felt a little better today, made the shims for the two couplings that > needed to go from an 8mm shaft to a 3/8" coupling, seems they'll work > just fine. Tomorrow bore the 1/2" out to 14mm. By then I might have the > card from PCW & can start configuring the computer, but I want to round > up some motor wire before I start the teardown. Thats something else > thats hard to come by in these here parts. I'll probably wind up at > Tolley Electric in Clarksburg for that. Need some cable chain to > contain the rats nest too, hope Tolley has that. > > Progress, from a one man circus. ;-) > > Cheers, Gene Heskett > Gene, Hope you're taking pics of this conversion. I've been tossing around the idea of converting my mill too, though it's been on the back burner for quite a while. Even one man circuses can manage to draw a crowd. ;-) Mark -- One Man, One Machine, One Computer! <VBSEG> ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
