Figured I would change the subject, On 7/15/2015 3:10 PM, Sebastian Kuzminsky wrote: > On 7/15/15 1:03 PM, Rick wrote: >> Sorry Seb, it's been a very long week with our machines, >> >> Between 2.6.6 and 2.6.5 >> >> We have been on 2.6.4 since it was released, and after I asked about the >> pin name changes the other day in gmoccapy, I came out and updated 1 of >> our turning centers, and noticed this problem, not thinking it was >> Linuxcnc, because it was the machine that the HD took a crap on. >> >> I just went through and started back at 2.6.4, compiled, loaded a >> program, halui.program.pause and halui.program.resume work fine, as soon >> as it see's the input, instantaneously I get the intended >> outputs/machine reaction. Did the same thing with 2.6.5, same results, >> instantaneous outputs. Did the same thing with 2.6.6, now I see a delay >> in the output of the intended input, by a second or so. > This must be a red herring, because the only change in halui between > 2.6.5 and 2.6.6 has to do with the management of Task modes during MDI > calls, nothing that should affect the handling of pause. > > Also, nothing at all changed in Task or Motion between those versions, > which are the other places a pause delay could happen. > >
-- Thanks Rick Lair Superior Roll & Turning LLC 399 East Center Street Petersburg MI, 49270 PH: 734-279-1831 FAX: 734-279-1166 www.superiorroll.com ------------------------------------------------------------------------------ Don't Limit Your Business. Reach for the Cloud. GigeNET's Cloud Solutions provide you with the tools and support that you need to offload your IT needs and focus on growing your business. Configured For All Businesses. Start Your Cloud Today. https://www.gigenetcloud.com/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
