On 9/20/2015 4:33 PM, Allen wrote: > Jim, > > I can't tell you how helpful these vids will be for folks like me. > So many question I had when I first saw the probe program where cleared up. > Thank you, and keep em coming.
I am glad that the videos were helpful. > > I had an idea for a video, those hal meters are pretty handy, could you > add to the the probe series with a how to to set those meters up? > If that's already been covered elsewhere, perhaps a link to point us in > the correct direction. > > Thanks again, Allen I will be covering the HAL tools in some upcoming videos. For now you can see the official man page for halmeter here: http://www.linuxcnc.org/docs/html/man/man1/halmeter.1.html <http://www.linuxcnc.org/docs/html/man/man1/halmeter.1.html> I believe that you can launch the halmeter boxes automatically by adding the commands to the launcher for your config. Can't really say for certain right now but I can try it when I get back to my machine. Maybe one of the wizards can chime in here. I am just an apprentice and haven't graduated to wizard yet and probably won't for many years. You can also see how to use it in the HAL manual here http://www.linuxcnc.org/docs/html/hal/tutorial.html#_halmeter <http://www.linuxcnc.org/docs/html/hal/tutorial.html#_halmeter> You can access the halmeter from the GUI's also. I don't remember exactly where it is in Axis as I don't use it very much, but it is located on the bottom of the settings page in Gmoccapy. Hope that helps. Jim ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
