On 10/12/2015 08:57 AM, Claude Zervas wrote: > Um, no, that HP 7800 SFF has *terrible* latency - it will spike up to > 133,000 after 20 minutes or so. > Based on Kirk's recommendation I bought the same one on ebay and installed > LinuxCNC 2.7 but the latency was really bad. I tried turning off every > power saving features in the bios and all the tricks listed in the LinuxCNC > wiki without success. > If someone has information about what can be done to fix the latency > problems on these machines I would really appreciate it! So far this > machine is basically an ugly door stop. > > thanks, > - Claude
Sorry if the HP didn't work for you. Mine are still working very well. Peter has been using these too. You might check with Peter Wallace at Mesa to see how his are working. -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/ ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
