I do recall we went through much more than expected just getting all that installed. And I don't have a complete list of all that was done.
I did poke around again on this machine. Mesaflash says the card's there at 10.10.10.10. After launching LinuxCNC, the VFD does respond to commands just fine. I experimented with the FERROR value- it'll allow the coordinates to change significantly before throwing an error, but the axes will never move regardless. The 7i92 won't put out steps at all. I don't have any enable line on it. Danny On 5/22/2016 6:27 PM, andy pugh wrote: > On 22 May 2016 at 19:51, Danny Miller <dan...@austin.rr.com> wrote: >> Any advice, folks? I've gotta move off that Dell machine ASAP and >> really want to avoid a whole reinstall. > I would suggest a complete reinstall of the OS and LinuxCNC, but keep > the same config files. The LinuxCNC config files should be entirely > portable. > ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
