Gene in this vid https://www.youtube.com/watch?v=ccYE0ICp5F8 he shows a better pyvcp panel ( and shows he's likely using a parport) AND hahaha hes using an old AGie 60L generator for power AND a home-made 'crossbow' wire feed on a stock sinker ( with linuxcnc moving the slides )
got a Polish friend? he's done a boatload of work on this. the webpage shows a lot more info Imea & Istema ( edm tooling mfctrs now defunct, bought out by Georg Fischer ) both made 'crossbows' to mount on sink edms the wire moved from left spool to right spool cutting direction was in YZ plane, the wire tool aligned with X Andre's setup is more like a coping saw than cross bow tomp tjtr33 On 07/21/16 06:35, Gene Heskett wrote: > On Wednesday 20 July 2016 14:30:43 dave wrote: > >> Hi gene, >> I may have come in too late: i.e. >> Day late and a dollar short. Welcome to the real world. >> IIUC you want a slot. EDM and a copper disk should do this >> quite nicely. Hope you get something working. >> >> Dave > I should have it in progress in another 15 minutes. But the disk > is .03125" brass I made and arbor for, and in case things are a little > warped, I ran it at about 300 and set the edge down of a skate bearing > hard enough to just barely bend it, then ran it back up the post very > slowly, which should result in it running dead true. And I can't find > the small cap, so the discharge is going to be REAL as the cap is a 10 > UF oil filled paper. Noisy as hell too. So we should be able to see if > its going to work yet tonight, > > Take care Dave. > > Cheers, Gene Heskett ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports.http://sdm.link/zohodev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
