I had to power cycle it this morning around 5am central time. JT
On 5/9/2017 7:24 AM, Sebastian Kuzminsky wrote: > It's up from here. > > http://isup.me/forum.linuxcnc.org > > > On May 9, 2017 1:49:45 AM MDT, "Bengt Sjölund" <[email protected]> wrote: >> And down again! >> >> What is it with the forum that goes down very often? >> >> Cheers >> Bengt >> >> >> Den 2017-04-30 kl. 19:58, skrev Jon Elson: >>> On 04/29/2017 04:26 PM, Jon Elson wrote: >>> And, it seems to be back up! >>> >>> Thanks, >>> >>> Jon >>> >>> >> ------------------------------------------------------------------------------ >>> Check out the vibrant tech community on one of the world's most >>> engaging tech sites, Slashdot.org! http://sdm.link/slashdot >>> _______________________________________________ >>> Emc-users mailing list >>> [email protected] >>> https://lists.sourceforge.net/lists/listinfo/emc-users >> >> ------------------------------------------------------------------------------ >> Check out the vibrant tech community on one of the world's most >> engaging tech sites, Slashdot.org! http://sdm.link/slashdot >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
