On 06/26/2017 01:46 PM, andy pugh wrote:
On 26 June 2017 at 21:03, dave <[email protected]> wrote:
"home" carefully nestled between the - and + jog buttons.
Now you have me curious; not certain where you are headed.
Curious that you don't have a "home all" button, but where I was heading
was that if you had been using "touch off" to zero the axes on a machine
with NO_FORCE_HOMING configured then an incremental step towards one or
other soft limit is likely.
Is G53 moving?
Opps! Didn't think to check. Darned!
I suspect so. My standard end of program goes:
G53G0Z0
G53G0X0Y7.5 ( to move out of the way of the tool)
G54G90
M2
and IIRC X was considerable displaced in the + direction.
Lets put this all on hold and see how things shake out with a new
encoder in place and hopefully
cooler temps. Tomorrow is supposed to be low 80's so about 10 degrees
cooler. :-)
Dave
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
