Hi Jeremy How do I calculage that and where would I do the correction in the settings? Thanks
On 28 Aug 2017 13:52, "jeremy youngs" <[email protected]> wrote: > My 860 drives gave me a very hard time early on.only much sifting through > the Chenglish did I realize the drive steps on the rise and fall. Requiring > 1/2 the steps calculated > > On Aug 27, 2017 11:12 PM, "Johann Beukes" <[email protected]> wrote: > > > Hi guys > > I am struggeling alot with my lathe X axis. The machine does not hold > size > > at all. I am using The Leadshine ESM-22430 motor and the DS808 drive. The > > Dirsetup is set at 2500, Dirhold 2500, Steplen 5000, Stepspace 5000 and > > stepscale at -322. The ballscrew has a 2.5mm pitch and the steps per rev > > are set at 800. > > Can anybody please give me some advice? > > Thanks > > ------------------------------------------------------------ > > ------------------ > > Check out the vibrant tech community on one of the world's most > > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
