I have attached the output from mesaflash. I have 4 or 5 25pin m-m cables. I have tried 3 different ones (new out of the bag (however made in china)).
W1 is right, W3 is left. I just noticed that the 5V LED is pulsing bright then dim about every three seconds. > On Aug 23, 2018, at 10:57 AM, Peter C. Wallace <p...@mesanet.com> wrote: > > On Thu, 23 Aug 2018, Condit Alan wrote: > >> Date: Thu, 23 Aug 2018 10:31:08 -0700 >> From: Condit Alan <condita...@yahoo.com <mailto:condita...@yahoo.com>> >> To: Wallace Peter C. <p...@mesanet.com <mailto:p...@mesanet.com>> >> Cc: "Emc-users@lists.sourceforge.net >> <mailto:Emc-users@lists.sourceforge.net>" <emc-users@lists.sourceforge.net >> <mailto:emc-users@lists.sourceforge.net>>, >> andy pugh <bodge...@gmail.com <mailto:bodge...@gmail.com>> >> Subject: Re: [Emc-users] pncconf error under 2.7.14 >> Peter, >> >> I have a separate 24V 2.5amp DIN rail power supply that powers fieldIO and a >> small pcb power supply (7805 plus a couple caps) that comes off of it to >> supply 5v power. I had the jumper in the wrong position for separate powers >> for field IO and separate 5v power. I changed that jumper. I was getting >> both oranges LEDs lit before and after the change, but could that have >> caused a problem? > > Its not likely but if you supply external 5V and you have the jumpers wrong > you can possibly damage the 5I25 card or the cable (thats why theres a > warning in the manual) That said, a 7805 is not likely to have enough current > to do any real damage > >> >> I checked all the other jumpers on both boards and everything is now >> correct. I have a short DB25M to DB25F ribbon cable to bring the 7i76 out to >> the back of the cabinet. I disconnected it and connected the 6ft 25pin DB25m >> to DB25m cable direct from the 5i25 to the 7i76 but no change in behavior. >> >> I noticed that in pncconf there are no tabs for TB2 or TB3. Also on TB4 >> there are no lines for SPINDLE-ENA or SPINDLE-DIR. Is that normal? > > I would not worry about pncconf at this point, if you have no 7I76 pins its > likely a hardware or firmware setup issue > > >> >> I bought the 5i25/7i76 pair directly from you so I assume that it has the >> correct firmware??? > > > I would check just to make sure > > sudo mesaflash --device 5i25 --readhmid > > Did you get the DB25 M-M cable from us also? > > > Are 7I76 W1 and W3 in the left hand positions? >> >> What else can I do? >> >> Alan >> > > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users