On Wed, 22 Aug 2018, Condit Alan wrote:
Date: Wed, 22 Aug 2018 16:28:43 -0700
From: Condit Alan <[email protected]>
To: Wallace Peter C. <[email protected]>
Cc: "[email protected]" <[email protected]>,
andy pugh <[email protected]>
Subject: Re: [Emc-users] pncconf error under 2.7.14
So what is the remedy for this?
typical issues:
No or too low field power
No 5V power
5I25 / 7I76 5V power options dont match
wrong firmware on 5I25
7I76 run/setup jumper in setup position
7I76 on wrong 5I25 connector
wrong cable
On Aug 22, 2018, at 3:22 PM, Peter C. Wallace <[email protected]> wrote:
Actually rather than a pncconf error, this sounds more like the 7I76's I/O
section is not found so no 7i76 pins will be present in hal
Peter Wallace
Mesa Electronics
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
