That encoder is probably using a custom protocol and can only be used
with systems specifically designed to work with it. You'll probably
struggle to get it to work with LinuxCNC.
Is the motor brushed or brushless? Brushed motors generally have two
main power wires, brushless normally have 3. If it's brushless, again it
could be hard work to get it running unless you have the driver designed
to work with it. If it's a brushed motor, pretty much any brushed motor
driver that can put out enough voltage and current will work with it.
Les
On 19/09/2019 18:10, Curtis Dutton wrote:
This encoder is a serial 17-bit with 4 wires. 0V, 5V, T+ and T-
On Thu, Sep 19, 2019 at 11:26 AM Todd Zuercher <[email protected]>
wrote:
Or
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
