The GUI installer has problems with my wifi dongle.  The dongle works fine
with after install.  The problem is that you can't bypass the network with
the GUI installer.

Dave

On Thu, Dec 19, 2019, 22:41 R C <cjv...@gmail.com> wrote:

> also,  on that Stretch installation.  if you try to install on anyting
> other then the first sata port, it names the device /dev/sde, even
> though it is /dev/sda
>
>
> I think the installer is broken, I have seen that earlier.
>
>
> Ron
>
> On 12/19/19 8:05 PM, Dave Matthews wrote:
> > Odd, Stepconf ran fineon the one I did.
> >
> > Dave
> >
> > On Thu, Dec 19, 2019, 21:54 R C <cjv...@gmail.com> wrote:
> >
> >> because a bunch of people were recommending it.
> >>
> >> Also, I managed to install "LinuxCNC Uspace 2.7.0 Debian 9 Stretch"
> >> <http://www.linuxcnc.org/testing-stretch-rtpreempt/>
> >>
> >>
> >> BUT:  there are two issues with that.
> >>
> >>
> >> 1:  It does not want to install if there is more than one drive in the
> >> system, which I can dodge by turning other drives off in the BIOS
> >>
> >>
> >> 2: There are issues with pyton,  it is trying to use something that is
> >> not there, files missing, when I start the "stepper config"
> >>
> >>
> >> Ron
> >>
> >>
> > _______________________________________________
> > Emc-users mailing list
> > Emc-users@lists.sourceforge.net
> > https://lists.sourceforge.net/lists/listinfo/emc-users
>
>
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
>

_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to