On Sun, 3 May 2020, Ed wrote:
Date: Sun, 3 May 2020 11:53:33 -0500
From: Ed <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: [email protected]
Subject: Re: [Emc-users] I can't seem to copy an error message
On 5/3/20 11:13 AM, andy pugh wrote:
On Sun, 3 May 2020 at 16:47, Ed <[email protected]> wrote:
Select All selects OK but I cannot do a copy to paste
into a message here. Any suggestions?
Are you saying that Ctrl-C doesn't work?
Nope. Ctrl-c nothing, right click nothing.
A doc in Mousepad it all works fine.
This is a new install of 2.7.14
When I started to install it gave some problems with USB initialization.
Maybe not a good candidate for a control.
Ed.
The easiest way I know to capture error messages (with the uspace version of
LinuxCNC you are running) is to start linuxcnc from the command line. All error
messages will be logged on the console which _can_ be copy-pasted
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
