On 8/17/20 3:52 AM, Gene Heskett wrote:
> This one is printing at the same scale as the output shaft, which I just > remade after finding they were to big to enter the main bearing even with > help from the assembly screws. So this will have a smaller bore, which means > I'll have to make a smaller internal spline, and that may demand a smaller > bearing carrier, as I need it to push the splines fully engaged, but only > enough clearance from pull-in that at the midpoint between the rollers, the > tips of the splines clear each other, this condition corresponds to the > minimum flex it needs to work=longest life. Maybe you should have started your 3D printing with a baby Yoda like everyone else. :-) >> 1500 mm/minute for all motion > Thats 3x the top speed setting in merlin. You may be seeing mm/second units rather than the mm/minute that I specified. 1500mm/min = 25mm/sec, fairly slow for a 3D printer. _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
