You can make a gladevcp or pyvcp button that activates a macro/mdi command.
See if this is helpful http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Adding_Custom_MDI_Buttons On Sat, Feb 27, 2021, 7:33 PM R C <cjv...@gmail.com> wrote: > I think I figured it out partially: > > > G0 G54 X0 Y0 > > G0 G54 Z0 > > > takes me 'safely' to where I touched off. > > > How can I create a button, or a "key combination", that does that? > > > Ron > > > > On 2/27/21 4:52 PM, R C wrote: > > Hello, > > > > > > is there a way, in axis, to pre-program a function key, or key > > combination, that can be used to execute some g-code? > > > > > > Also, is there a way to go back to the point/spot where you touched > > off at the end of a run? (X, Y first, then Z axis) ? > > > > > > thanks, > > > > > > Ron > > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users