That looks like exactly what it is that I want to do.
(I probably have to play with the 'MDI_COMMAND a bit, since I want to
do that in 2 steps. First go to the x0, y0 position and after that to
the Z0, to prevent crashing into anything)
thanks!!
Ron
On 2/28/21 3:27 PM, Feral Engineer wrote:
You can make a gladevcp or pyvcp button that activates a macro/mdi command.
See if this is helpful
http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Adding_Custom_MDI_Buttons
On Sat, Feb 27, 2021, 7:33 PM R C <cjv...@gmail.com> wrote:
I think I figured it out partially:
G0 G54 X0 Y0
G0 G54 Z0
takes me 'safely' to where I touched off.
How can I create a button, or a "key combination", that does that?
Ron
On 2/27/21 4:52 PM, R C wrote:
Hello,
is there a way, in axis, to pre-program a function key, or key
combination, that can be used to execute some g-code?
Also, is there a way to go back to the point/spot where you touched
off at the end of a run? (X, Y first, then Z axis) ?
thanks,
Ron
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
