Happy to help, sir 👌👌 On Sun, Feb 28, 2021, 5:47 PM R C <cjv...@gmail.com> wrote:
> That looks like exactly what it is that I want to do. > > (I probably have to play with the 'MDI_COMMAND a bit, since I want to > do that in 2 steps. First go to the x0, y0 position and after that to > the Z0, to prevent crashing into anything) > > thanks!! > > > Ron > > > > On 2/28/21 3:27 PM, Feral Engineer wrote: > > You can make a gladevcp or pyvcp button that activates a macro/mdi > command. > > > > See if this is helpful > > > > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Adding_Custom_MDI_Buttons > > > > On Sat, Feb 27, 2021, 7:33 PM R C <cjv...@gmail.com> wrote: > > > >> I think I figured it out partially: > >> > >> > >> G0 G54 X0 Y0 > >> > >> G0 G54 Z0 > >> > >> > >> takes me 'safely' to where I touched off. > >> > >> > >> How can I create a button, or a "key combination", that does that? > >> > >> > >> Ron > >> > >> > >> > >> On 2/27/21 4:52 PM, R C wrote: > >>> Hello, > >>> > >>> > >>> is there a way, in axis, to pre-program a function key, or key > >>> combination, that can be used to execute some g-code? > >>> > >>> > >>> Also, is there a way to go back to the point/spot where you touched > >>> off at the end of a run? (X, Y first, then Z axis) ? > >>> > >>> > >>> thanks, > >>> > >>> > >>> Ron > >>> > >> > >> _______________________________________________ > >> Emc-users mailing list > >> Emc-users@lists.sourceforge.net > >> https://lists.sourceforge.net/lists/listinfo/emc-users > >> > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users