I ran the following commands from the MDI without issue from AXIS 2.8.1 with MESA 7i92H controlling an AC Servo motor (step/dir) for the spindle. G1 X0 Y0 F20 G1 Z0 S200 M3 G33.1 Z-0.7 K0.05 I3.0 M5
Interesting watching the spindle RPM indicator, and you can hear it too of course. Goes down to tap the 0.05" pitch (20TPI thread) at 200RPM Reverses and goes up at 600 RPM. Without the I3.0 it goes up at 200 RPM. John -----Original Message----- From: Nicklas SB Karlsson [mailto:n...@nksb.eu] Sent: June 25, 2023 9:07 AM To: emc-users@lists.sourceforge.net Subject: Re: [Emc-users] G33.1 error then g-code file parsed There is positioning move XYZ in real program but happened to remove them then I should make a small test case. Adding positioning move to test case make no difference. Linuxcnc report a file interpretation error and do not update display but program seems to work supposed to. Nicklas Karlsson Den 2023-06-23 kl. 16:20, skrev Chris Radek: > I would add positioning moves (positioning all of XYZ) before the > G33.1 because otherwise the tapped hole can be anywhere - the > program is indeterminate. This sure might mess up any attempt by > your GUI to check the program or generate a preview. > > Chris > > On Wed, Jun 14, 2023 at 09:14:20PM +0200, Nicklas SB Karlsson wrote: >> I put the lines below into a file: >> >> ?? M3 S100 >> ?? G33.1 Z-30.474 K0.8 I3.000 >> ?? M5 >> ?? M2 >> >> Then I read into Linuxcnc I get error message: >> >> ?? parse_file interp_error >> >> Removing the line with G33.1 then no error message so it is something >> with this row. Program do however execute as expected with G33.1 line >> even though there is an error message so no real problem. Also execute >> without an error message if run manually in MDI mode. Use origin/master >> last commit Mon May 8 16:10:03 2023 +0200 >> 404aa407f136ce91a3e6bf911c7bda54011a74e9 Anybody else had similar problem? >> >> >> Nicklas Karlsson >> >> >> >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users