Ok so I'm a 4yr old in this world so my Apologizes  if this is lame but perhaps 
it will spark some idea in someone that is more skilled......ok here goes....

If you used the speed sensor to feed Rpm data to an arduino duo programmed to a 
switching contactor that switches the voltages from series to parallel coupled 
with something like a precharge resistor to keep Amps the same but ramp up the 
voltage wouldn't you be able to accomplish what the hairball does but at a 
lower amperage and speed then one would need for drag racing?? Thus making it 
more cost effective and hobbyist friendly????

 I'm  sure there's about ten steps i'm not thinking of and i have no clue where 
this would go in the system but that being said id love to hear everyones 
thoughts!!

Drewcifer

Sent from my iPhone

On Feb 5, 2013, at 7:49 PM, "EVDL Administrator [via Electric Vehicle 
Discussion List]" <[email protected]> wrote:

On 5 Feb 2013 at 13:53, Drewcifer wrote: 

> Coul you use a  Zolox Motor Speed Sensor Kit DL9-2171s or something 
> similar to set up series and parallel switching?  Could it be linked to a 
> separate contractor to [shut] down the controller [without] adversely 
> affecting the motors? 

What is it that you'd like to connect in parallel and series depending on 
motor speed?  The two motors? What's the objective here? 

David Roden 
EVDL Administrator 
http://www.evdl.org/


_______________________________________________ 
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
For EV drag racing discussion, please use NEDRA 
(http://groups.yahoo.com/group/NEDRA) 



If you reply to this email, your message will be added to the discussion below:
http://electric-vehicle-discussion-list.413529.n4.nabble.com/Series-and-parallel-switching-tp4661043p4661046.html
To unsubscribe from Series and parallel switching, click here.
NAML



--
View this message in context: 
http://electric-vehicle-discussion-list.413529.n4.nabble.com/Series-and-parallel-switching-tp4661043p4661065.html
Sent from the Electric Vehicle Discussion List mailing list archive at 
Nabble.com.
_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
For EV drag racing discussion, please use NEDRA 
(http://groups.yahoo.com/group/NEDRA)

Reply via email to