FYI service shorewall clear will clear the firewall service shorewall stop stops it.
On Thursday 09 January 2003 09:35 pm, Jim C wrote: > Experience tells me that when I stop shorewall from the command line > (i.e. "service shorewall stop" from the superuser bash prompt) my > network gets locked down. Ah dunno why. What I do to turn it off is go > into Control Center and select Security | Firewall and then unselect > everything except the Everything button. Then I do "service shorewall > restart" just for good measure. Alternatively, one can just check the > ssh button to allow access on ssh's port. > > Geeze, when is Mandrake going to get a decent per-ethernet card GUI > firewall configurator with an advanced option that covers GUI > configuration for all the protocols for say port 1000 and below, an > Internet Connection Shareing on/off button as well as a configure > button. Heck, I could probably write it and I can't even get a > Samba-LDAP PDC to run. ;-) > > > Jim C. > > Pierre Fortin wrote: > > Stop or remove "shorewall" -- sure wish Mdk would have made it more > > obvious during install/upgrade that it was going to add a firewall > > without asking... > > > > :^Pierre > > > > On Thu, 9 Jan 2003 18:16:19 -0500 Brian York <[EMAIL PROTECTED]> > > > > wrote: > >>I just installed mandrake 9 and I can't get ssh in to it. Its running > >>but I get an error message connection closed by remote host. When I > >>installed it I used 'higher' security. > >> > >>Thanks > >>Brian > > > > ------------------------------------------------------------------------ > > > > Want to buy your Pack or Services from MandrakeSoft? > > Go to http://www.mandrakestore.com
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com