Sorry guys... I know the attribution is wrong... reporting as a bug to sylpheed-claws now...
On Mon, 29 Sep 2003 07:20:23 -0400 Pierre Fortin <[EMAIL PROTECTED]> wrote: > On Sun, 28 Sep 2003 21:00:02 -0700 James Sparenberg > <[EMAIL PROTECTED]> wrote: > > > > different cards - so far: a Netgear FA511 and a Xircom XE2000. Both > > > are detected correctly, but none would work with DHCP anymore (the > > > original one did). And even under the scenario of having to manually > > > change the IP addresses between home and work (where is that > > > multiple profile - promised land thingy?!?), it works only if > > > running first drakconf, changing everything (IP, mask, gateway, DNS, > > > etc.), NOT working - though - the first time, then running # > > > ifconfig eth0 with the parameters needed to setup the IP and > > > netmask, then running # route for the new default - and, at this > > > stage, the things still won't work - then again drakconf - after > > > which - finally - the network starts properly. Attempted between > > > each of the above steps a "service network restart", with the eth0 > > > always failing ... and "NO" - it won't work if I would just run > > > ifconfig first, then drakconf: it seems to work only if: changes in > > > drakconf --> no go --> ifconfig eth0 and route --> no go --> again > > > drakconf --> finally! ... > > Wish I'd seen this sooner... *appears* I had this very problem with > 9.2rc2 while on a road trip last week, though I never thought of > retrying the conf TWICE... <sigh>
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
