I understand, but do you create them every time you edit the score? I'm asking because I had them previously created and in place, when one of them (only one) disappeared after some score editing. All others were in place. Harold
At 13:22 -0400 09/05/10, Christopher Smith wrote: >I don't bother checking. I just Create multimeasure rests for parts/score and >select all. That way I know it's done. There are usually layout issues to >address in any case when I add material. If I have any fancy measure widths, I >usually have them under a keyboard shortcut, so I put them in again. > >Christopher > > >On Sun May 9, at SundayMay 9 1:16 PM, Haroldo Mauro Jr. wrote: > >>Good, I'll just do that then. Thanks. How would one be sure, that whenever >>one goes back to the score for editing, the already existing parts will have >>no missing measures? Do I need to check all parts over and over again every >>time I make changes to the score? >>Harold >> >> >>At 12:49 -0400 09/05/10, Christopher Smith wrote: >>>Just create again. Unless you have some fancy stuff in there (broken rests, >>>special widths for multimeasure rest bars), everything will just be right. >>>If you are worried about any fancy stuff you may have created, select the >>>passage in the part with the Selection Tool, then Create just for that >>>passage. Nothing else will change, then. >>> >>>Christopher >>> >>> >>> >>>On Sun May 9, at SundayMay 9 12:10 PM, Haroldo Mauro Jr. wrote: >>> >>>>At 17:55 +0200 09/05/10, dc wrote: >>>>>Haroldo Mauro Jr. écrit: >>>>>>I've generated parts from a score, adjusted them and they were fine a >>>>>>moment ago. Then I did some editing in the score. Now there are missing >>>>>>measures in two parts. Section "F" of the score has 19 measures, but only >>>>>>9 are showing in these parts. Is there anything I should do to make them >>>>>>apear on the parts, other than generate them again? >>>>> >>>>>I seem to recall you have to update the multimeasure rests. >>>>> >>>>>Dennis >>>> >>>>I can't find anything related to "update multimeasure rests" in the menus. >>>>I tried update layout, but didn't fix it. The part already has several >>>>multimeasure rest, so I guess it doesn't make sense to chose "Create >>>>multimeasure rests for part/score". There is actually one 9-bar >>>>multimeasure rest missing. >>>>Harold > > >_______________________________________________ >Finale mailing list >Finale@shsu.edu >http://lists.shsu.edu/mailman/listinfo/finale _______________________________________________ Finale mailing list Finale@shsu.edu http://lists.shsu.edu/mailman/listinfo/finale
