Robert,
Since the 6700 does not have any rs232 support I doubt that you can
make a direct connect that would drive the Step IR. I believe that
those that are using the 6700 with Step IR are using a connection to the
PC...
I'm not sure how many 6K folks are on this list. You might get a
better answer on the preview list.
AL, K0VM
( I have a 65090 but no StepIR )
On 7/23/2013 1:12 PM, Robin Haighton wrote:
I recently purchased and installed a 3 element stepp ir antenna. A fantastic improvement
on my previous Cushcraft A3. However now I have a flex6700 which should be able to
adjust the Steppir as I change Band and frequency. The new antenna came with two
"S12"cables which I presume are to directly connect the 6700 to the Steppir
controller. Can anyone confirm that this is a direct connection or do I need to go
through another device such as a computer serial port?
Any advice or experience would be very welcome.
I also have a flex 3000 can I use the same cable or do I need a different one?
73
Robin Haighton VE3FRH
Sent from my iPad
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software innovation and other technical SDR
topics.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software innovation and other technical SDR
topics.
