Hi Al, Robin and I are working to get his SteppIR working with his 6700....
Dennis KØEOO ----- Original Message ----- From: "Al K0VM" <[email protected]> To: [email protected] Sent: Friday, July 26, 2013 11:13:54 AM Subject: Re: [FlexEdge] Steppir and 6700. Robert, Since the 6700 does not have any rs232 support I doubt that you can make a direct connect that would drive the Step IR. I believe that those that are using the 6700 with Step IR are using a connection to the PC... I'm not sure how many 6K folks are on this list. You might get a better answer on the preview list. AL, K0VM ( I have a 65090 but no StepIR ) On 7/23/2013 1:12 PM, Robin Haighton wrote: > I recently purchased and installed a 3 element stepp ir antenna. A fantastic > improvement on my previous Cushcraft A3. However now I have a flex6700 which > should be able to adjust the Steppir as I change Band and frequency. The new > antenna came with two "S12"cables which I presume are to directly connect the > 6700 to the Steppir controller. Can anyone confirm that this is a direct > connection or do I need to go through another device such as a computer > serial port? > Any advice or experience would be very welcome. > I also have a flex 3000 can I use the same cable or do I need a different one? > > 73 > Robin Haighton VE3FRH > > > > > > Sent from my iPad > _______________________________________________ > Flexedge mailing list > [email protected] > http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz > This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used > for posting topics related to SDR software innovation and other technical SDR > topics. > _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software innovation and other technical SDR topics. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software innovation and other technical SDR topics.
