Not sure if this will help or not, it sounds like it should have worked.
You need to read a little further down on Phil's page -- take a look @ the entry for "May 14, 2005" on Phil's page - that's pretty much where the details on vCOM start.
Basically, you need to edit the .INF file to select com port nums if you want to use something other than 4 or 5. If you already have something at COM4 or COM5 you must do this of course. This needs to be done before installing the driver
When asked which driver to install you probably want the objfre one, it does not have the debugging stuff the checked one does
After rebooting look in device manger, under multiple port serial adapters, it should show N8VB's vCom driver without any red or yellow decorations.
Tell HRD to use one of the ports, tell SDR to use the other. You need to be running one of my experimentals (1.3.5, 1.3.7) with the HRD fix, or need to be running Flex 1.3.8 -- 1.3.7 may work, I forget exactly which driver the HRD CAT fix went into.
Regards, Bill (kd5tfd) At 08:22 AM 6/21/2005, Larry Loen wrote:
I am having trouble getting N8VB's virtual comm device driver going......
