Mike, Good suggestion, but less useful for those who use gold-plated plugs in solid brass.
Willi ----- Original Message ----- From: "Mike Naruta" <[EMAIL PROTECTED]> To: "'FlexRadio Mailing List'" <FlexRadio@flex-radio.biz> Sent: Tuesday, September 26, 2006 6:07 PM Subject: Re: [Flexradio] Poor sideband suppression > Rather than enlarge the hole, I used a > knife to shave the plastic on the plug end. > > > Mike - AA8K > > > > Willi Reppel wrote: >> Larry, >> >> To the best of my knowledge, I cannot recall an offi-cial warning from >> Flex.Radio against the use of gold-plated plugs. In contrary, these were >> praised many times as problem solvers on the forum and reflector without >> objections. Anyhow, they solved my problems and twisting is now done only >> on >> dance floors. To avoid the introduction of new problems, I mentioned the >> required enlargement of the connector admission holes when using >> gold-plated >> plugs. >> >> vy 73 es best dx de SM6OMH Willi > > _______________________________________________ > FlexRadio mailing list > FlexRadio@flex-radio.biz > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > FlexRadio Homepage: http://www.flex-radio.com > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com