Just:
take RESPACK1 copy it to your own library
change it's name to something else
delete the last 4 parts of the component,
renumber high pins
change the default footprint.
Save the library.
You should be able to do it in all of 10 minutes. At least that is all
the time it took me to create a 2 resistor version a while back.
Rob
"Tim Hutcheson" <[EMAIL PROTECTED]> on 06/06/2001 03:57:03 PM
Please respond to "Protel EDA Forum" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
cc: (bcc: Rob LaMoreaux/DSPT)
Subject: Re: [PEDA] Resistor pack?
Yes, thanks, I was aware of those. I would just define a simple 4-part but
I need to figure out how to define it like the RESPACK1 part, show that it
displays as a single resistor. The book doesn't go into much detail about
how to do this. I have to define 4-part packs for source termination of a
microprocessor bus. So the individual resistors have to be scattered in
the
schematic but associated by pin number and pack designator. Seemed like
such a common requirement that I expected to fined something in the
library.
Maybe someone has suggestions? TIA
regards,
Tim Hutcheson
Institute for Human and Machine Cognition
40 S. Alcaniz St.
Pensacola, FL 32503
[EMAIL PROTECTED]
ICQ# 32491889
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
