Thanks. At this point I'm just trying to get the ports to come up, so it's the simplest config in the world. 2402 connected via port 26 to SI-GT on port 4/9 with a crossover cable. It's 11.0 code, and it's worked in other machines, though I don't have any currently running that code.
2402: FES2402 Switch#sho run Current configuration: ! ver 04.0.00aTc1 ! ! ! ! ! ! ! ip address 192.168.0.64 255.255.255.0 ! ! ! ! ! ! end FES2402 Switch#sho int e 26 GigabitEthernet26 is up Link Error Dampening is Disabled Hardware is GigabitEthernet, address is 000c.db1d.4769 (bia 000c.db1d.4769) Configured speed 1Gbit, actual 1Gbit, configured duplex fdx, actual fdx Configured mdi mode AUTO, actual MDI Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING BPDU guard is Disabled, ROOT protect is Disabled Link Error Dampening is Disabled STP configured to ON, priority is level0 Flow Control is config enabled, oper enabled, negotiation disabled mirror disabled, monitor disabled Not member of any active trunks Not member of any configured trunks No port name IP MTU 1500 bytes 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization 300 second output rate: 640 bits/sec, 1 packets/sec, 0.00% utilization 6461218 packets input, 423261535 bytes, 0 no buffer Received 4282 broadcasts, 21834 multicasts, 6424644 unicasts 0 input errors, 0 CRC, 0 frame, 0 ignored 0 runts, 0 giants, DMA received 6461218 packets 6746678 packets output, 1994941951 bytes, 0 underruns Transmitted 189434 broadcasts, 124538 multicasts, 6432706 unicasts 0 output errors, 0 collisions, DMA transmitted 6746678 packets FES2402 Switch#sho int bri Port Link State Dupl Speed Trunk Tag Priori MAC Name 1 Down None None None None No level0 000c.db1d.4750 2 Down None None None None No level0 000c.db1d.4751 3 Down None None None None No level0 000c.db1d.4752 4 Down None None None None No level0 000c.db1d.4753 5 Down None None None None No level0 000c.db1d.4754 6 Down None None None None No level0 000c.db1d.4755 7 Down None None None None No level0 000c.db1d.4756 8 Down None None None None No level0 000c.db1d.4757 9 Down None None None None No level0 000c.db1d.4758 10 Down None None None None No level0 000c.db1d.4759 11 Down None None None None No level0 000c.db1d.475a 12 Down None None None None No level0 000c.db1d.475b 13 Down None None None None No level0 000c.db1d.475c 14 Down None None None None No level0 000c.db1d.475d 15 Down None None None None No level0 000c.db1d.475e 16 Down None None None None No level0 000c.db1d.475f 17 Down None None None None No level0 000c.db1d.4760 18 Down None None None None No level0 000c.db1d.4761 19 Down None None None None No level0 000c.db1d.4762 20 Down None None None None No level0 000c.db1d.4763 21 Down None None None None No level0 000c.db1d.4764 22 Down None None None None No level0 000c.db1d.4765 23 Up Forward Full 100M None No level0 000c.db1d.4766 24 Up Forward Full 100M None No level0 000c.db1d.4767 25 Up Forward Full 1G None No level0 000c.db1d.4768 26 Up Forward Full 1G None No level0 000c.db1d.4769 FES2402 Switch# SI-GT: ServerIronGT E-1#sho run !Building configuration... !Current configuration : 378 bytes ! ver 11.0.00TD4 ! module 1 bi-0-port-wsm6-management-module module 3 bi-jc-2-port-gig-module module 4 bi-jc-16-port-gig-copper-module ! context default ! aaa authentication web-server default local no enable aaa console telnet server username admin password ..... snmp-server ! interface ethernet 4/9 ip address 192.168.0.77 255.255.255.0 ! end ServerIronGT E-1#sho int e 4/9 GigabitEthernet4/9 is down, line protocol is down Hardware is GigabitEthernet, address is 000c.dbb5.b668 (bia 000c.dbb5.b668) Configured speed auto, actual unknown, configured duplex fdx, actual unknown Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING STP configured to ON, priority is level0, flow control enabled mirror disabled, monitor disabled Not member of any active trunks Not member of any configured trunks No port name Internet address is 192.168.0.77/24, MTU 1518 bytes, encapsulation ethernet 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization 300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization 6096 packets input, 507641 bytes, 0 no buffer Received 4256 broadcasts, 1838 multicasts, 2 unicasts 0 input errors, 0 CRC, 0 frame, 0 ignored 0 runts, 0 giants, DMA received 0 packets 0 packets output, 0 bytes, 0 underruns Transmitted 0 broadcasts, 0 multicasts, 0 unicasts 0 output errors, 0 collisions, DMA transmitted 0 packets ServerIronGT E-1#sho int bri Port Link State Dupl Speed Trunk Tag Priori MAC Name 4/1 Down None None None None No level0 000c.dbb5.b660 4/2 Down None None None None No level0 000c.dbb5.b661 4/3 Down None None None None No level0 000c.dbb5.b662 4/4 Down None None None None No level0 000c.dbb5.b663 4/5 Down None None None None No level0 000c.dbb5.b664 4/6 Down None None None None No level0 000c.dbb5.b665 4/7 Down None None None None No level0 000c.dbb5.b666 4/8 Down None None None None No level0 000c.dbb5.b667 4/9 Down None None None None No level0 000c.dbb5.b668 4/10 Down None None None None No level0 000c.dbb5.b669 4/11 Down None None None None No level0 000c.dbb5.b66a 4/12 Down None None None None No level0 000c.dbb5.b66b 4/13 Down None None None None No level0 000c.dbb5.b66c 4/14 Down None None None None No level0 000c.dbb5.b66d 4/15 Down None None None None No level0 000c.dbb5.b66e 4/16 Down None None None None No level0 000c.dbb5.b66f ServerIronGT E-1# On Fri, Feb 20, 2009 at 12:06 PM, Daniel Kekai <[email protected]>wrote: > Send the output on the FES side interface and if possible the configs for > both the GT and FES > > Also do you have this setup working with other GT's – FES? If so are you > running the same code? > > > > -D > > > > *From:* Chuck Ufarley [mailto:[email protected]] > *Sent:* Friday, February 20, 2009 11:17 AM > *To:* Daniel Kekai > *Cc:* [email protected] > *Subject:* Re: [f-nsp] Port state blocking? > > > > It seems to be disabled. Should I enable it? This hasn't been an issue in > past configs. > > ServerIronGT E-1#sho span > > Spanning-tree is not configured on port-vlan 1. > > Thanks again. > > On Fri, Feb 20, 2009 at 11:01 AM, Daniel Kekai <[email protected]> > wrote: > > Check your spanning tree > > -D > > > > *From:* [email protected] [mailto: > [email protected]] *On Behalf Of *Chuck Ufarley > *Sent:* Friday, February 20, 2009 9:51 AM > *To:* [email protected] > *Subject:* [f-nsp] Port state blocking? > > > > This might be a silly question, but I can't get a port to come up on a > ServerIron. I enabled the interface and connected it properly to a > FES-X2402 switch, but the J-B16GC and the J-B2Gx ports just won't come up > and forward. The cards have worked in other configs, but I can't get > anything to come out of "blocking" mode. Here are the shows (any help > greatly appreciated): > > ServerIronGT E-1#sho run > !Building configuration... > !Current configuration : 378 bytes > ! > ver 11.0.00TD4 > ! > module 1 bi-0-port-wsm6-management-module > module 3 bi-jc-2-port-gig-module > module 4 bi-jc-16-port-gig-copper-module > ! > context default > ! > aaa authentication web-server default local > no enable aaa console > telnet server > username admin password ..... > snmp-server > ! > interface ethernet 4/9 > ip address 192.168.0.77 255.255.255.0 > ! > end > > ServerIronGT E-1#sho run > !Building configuration... > !Current configuration : 378 bytes > ! > ver 11.0.00TD4 > ! > module 1 bi-0-port-wsm6-management-module > module 3 bi-jc-2-port-gig-module > module 4 bi-jc-16-port-gig-copper-module > ! > context default > ! > aaa authentication web-server default local > no enable aaa console > telnet server > username admin password ..... > snmp-server > ! > interface ethernet 4/9 > ip address 192.168.0.77 255.255.255.0 > ! > end > > ServerIronGT E-1#sho mod > Module Status Ports Starting MAC > S1: B0GMR WSM6 Management Module, SYSIF 2 M6, ACTIV 0 > S2: > S3: J-BxG2 JetCore Gig Fiber Module, SYSIF OK 2 000c.dbb5.b640 > S4: J-BxGC16 JetCore Gig Copper Module, SY OK 16 000c.dbb5.b660 > ServerIronGT E-1#sho int e 4/9 > GigabitEthernet4/9 is down, line protocol is down > Hardware is GigabitEthernet, address is 000c.dbb5.b668 (bia > 000c.dbb5.b668) > Configured speed auto, actual unknown, configured duplex fdx, actual > unknown > Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING > STP configured to ON, priority is level0, flow control enabled > mirror disabled, monitor disabled > Not member of any active trunks > Not member of any configured trunks > No port name > Internet address is 192.168.0.77/24, MTU 1518 bytes, encapsulation > ethernet > 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization > 300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization > 991 packets input, 77378 bytes, 0 no buffer > Received 581 broadcasts, 410 multicasts, 0 unicasts > 0 input errors, 0 CRC, 0 frame, 0 ignored > 0 runts, 0 giants, DMA received 0 packets > 0 packets output, 0 bytes, 0 underruns > Transmitted 0 broadcasts, 0 multicasts, 0 unicasts > 0 output errors, 0 collisions, DMA transmitted 0 packets > ServerIronGT E-1# > > +++++ > > Thanks much, everyone. > > >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
