Thanks, daniel-- But it's still blocking. Reloading the SI-GT, blocking. Trying "no span," blocking. Trying "enable," blocking. Strange. I can't figure out what's causing it.
On Mon, Feb 23, 2009 at 10:59 AM, Daniel Kekai <[email protected]>wrote: > On the GT go to the interface config on 4/9 and type in: > > > > no spanning-tree > > > > Then test again > > > > -daniel > > > > *From:* Chuck Ufarley [mailto:[email protected]] > *Sent:* Friday, February 20, 2009 1:19 PM > > *To:* Daniel Kekai > *Cc:* [email protected] > *Subject:* Re: [f-nsp] Port state blocking? > > > > Thanks. At this point I'm just trying to get the ports to come up, so it's > the simplest config in the world. 2402 connected via port 26 to SI-GT on > port 4/9 with a crossover cable. It's 11.0 code, and it's worked in other > machines, though I don't have any currently running that code. > > 2402: > > FES2402 Switch#sho run > Current configuration: > ! > ver 04.0.00aTc1 > ! > ! > ! > ! > ! > ! > ! > ip address 192.168.0.64 255.255.255.0 > ! > ! > ! > ! > ! > ! > end > > FES2402 Switch#sho int e 26 > GigabitEthernet26 is up > Link Error Dampening is Disabled > Hardware is GigabitEthernet, address is 000c.db1d.4769 (bia > 000c.db1d.4769) > Configured speed 1Gbit, actual 1Gbit, configured duplex fdx, actual fdx > Configured mdi mode AUTO, actual MDI > Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING > BPDU guard is Disabled, ROOT protect is Disabled > Link Error Dampening is Disabled > STP configured to ON, priority is level0 > Flow Control is config enabled, oper enabled, negotiation disabled > mirror disabled, monitor disabled > Not member of any active trunks > Not member of any configured trunks > No port name > IP MTU 1500 bytes > 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization > 300 second output rate: 640 bits/sec, 1 packets/sec, 0.00% utilization > 6461218 packets input, 423261535 bytes, 0 no buffer > Received 4282 broadcasts, 21834 multicasts, 6424644 unicasts > 0 input errors, 0 CRC, 0 frame, 0 ignored > 0 runts, 0 giants, DMA received 6461218 packets > 6746678 packets output, 1994941951 bytes, 0 underruns > Transmitted 189434 broadcasts, 124538 multicasts, 6432706 unicasts > 0 output errors, 0 collisions, DMA transmitted 6746678 packets > FES2402 Switch#sho int bri > > Port Link State Dupl Speed Trunk Tag Priori MAC Name > 1 Down None None None None No level0 000c.db1d.4750 > 2 Down None None None None No level0 000c.db1d.4751 > 3 Down None None None None No level0 000c.db1d.4752 > 4 Down None None None None No level0 000c.db1d.4753 > 5 Down None None None None No level0 000c.db1d.4754 > 6 Down None None None None No level0 000c.db1d.4755 > 7 Down None None None None No level0 000c.db1d.4756 > 8 Down None None None None No level0 000c.db1d.4757 > 9 Down None None None None No level0 000c.db1d.4758 > 10 Down None None None None No level0 000c.db1d.4759 > 11 Down None None None None No level0 000c.db1d.475a > 12 Down None None None None No level0 000c.db1d.475b > 13 Down None None None None No level0 000c.db1d.475c > 14 Down None None None None No level0 000c.db1d.475d > 15 Down None None None None No level0 000c.db1d.475e > 16 Down None None None None No level0 000c.db1d.475f > 17 Down None None None None No level0 000c.db1d.4760 > 18 Down None None None None No level0 000c.db1d.4761 > 19 Down None None None None No level0 000c.db1d.4762 > 20 Down None None None None No level0 000c.db1d.4763 > 21 Down None None None None No level0 000c.db1d.4764 > 22 Down None None None None No level0 000c.db1d.4765 > 23 Up Forward Full 100M None No level0 000c.db1d.4766 > 24 Up Forward Full 100M None No level0 000c.db1d.4767 > 25 Up Forward Full 1G None No level0 000c.db1d.4768 > 26 Up Forward Full 1G None No level0 000c.db1d.4769 > FES2402 Switch# > > SI-GT: > > ServerIronGT E-1#sho run > !Building configuration... > !Current configuration : 378 bytes > ! > ver 11.0.00TD4 > ! > module 1 bi-0-port-wsm6-management-module > module 3 bi-jc-2-port-gig-module > module 4 bi-jc-16-port-gig-copper-module > ! > context default > ! > aaa authentication web-server default local > no enable aaa console > telnet server > username admin password ..... > snmp-server > ! > interface ethernet 4/9 > ip address 192.168.0.77 255.255.255.0 > ! > end > > ServerIronGT E-1#sho int e 4/9 > GigabitEthernet4/9 is down, line protocol is down > Hardware is GigabitEthernet, address is 000c.dbb5.b668 (bia > 000c.dbb5.b668) > Configured speed auto, actual unknown, configured duplex fdx, actual > unknown > Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING > STP configured to ON, priority is level0, flow control enabled > mirror disabled, monitor disabled > Not member of any active trunks > Not member of any configured trunks > No port name > Internet address is 192.168.0.77/24, MTU 1518 bytes, encapsulation > ethernet > 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization > 300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization > 6096 packets input, 507641 bytes, 0 no buffer > Received 4256 broadcasts, 1838 multicasts, 2 unicasts > 0 input errors, 0 CRC, 0 frame, 0 ignored > 0 runts, 0 giants, DMA received 0 packets > 0 packets output, 0 bytes, 0 underruns > Transmitted 0 broadcasts, 0 multicasts, 0 unicasts > 0 output errors, 0 collisions, DMA transmitted 0 packets > ServerIronGT E-1#sho int bri > > Port Link State Dupl Speed Trunk Tag Priori MAC Name > 4/1 Down None None None None No level0 000c.dbb5.b660 > 4/2 Down None None None None No level0 000c.dbb5.b661 > 4/3 Down None None None None No level0 000c.dbb5.b662 > 4/4 Down None None None None No level0 000c.dbb5.b663 > 4/5 Down None None None None No level0 000c.dbb5.b664 > 4/6 Down None None None None No level0 000c.dbb5.b665 > 4/7 Down None None None None No level0 000c.dbb5.b666 > 4/8 Down None None None None No level0 000c.dbb5.b667 > 4/9 Down None None None None No level0 000c.dbb5.b668 > 4/10 Down None None None None No level0 000c.dbb5.b669 > 4/11 Down None None None None No level0 000c.dbb5.b66a > 4/12 Down None None None None No level0 000c.dbb5.b66b > 4/13 Down None None None None No level0 000c.dbb5.b66c > 4/14 Down None None None None No level0 000c.dbb5.b66d > 4/15 Down None None None None No level0 000c.dbb5.b66e > 4/16 Down None None None None No level0 000c.dbb5.b66f > ServerIronGT E-1# > > On Fri, Feb 20, 2009 at 12:06 PM, Daniel Kekai <[email protected]> > wrote: > > Send the output on the FES side interface and if possible the configs for > both the GT and FES > > Also do you have this setup working with other GT's – FES? If so are you > running the same code? > > > > -D > > > > *From:* Chuck Ufarley [mailto:[email protected]] > *Sent:* Friday, February 20, 2009 11:17 AM > *To:* Daniel Kekai > *Cc:* [email protected] > *Subject:* Re: [f-nsp] Port state blocking? > > > > It seems to be disabled. Should I enable it? This hasn't been an issue in > past configs. > > ServerIronGT E-1#sho span > > Spanning-tree is not configured on port-vlan 1. > > Thanks again. > > On Fri, Feb 20, 2009 at 11:01 AM, Daniel Kekai <[email protected]> > wrote: > > Check your spanning tree > > -D > > > > *From:* [email protected] [mailto: > [email protected]] *On Behalf Of *Chuck Ufarley > *Sent:* Friday, February 20, 2009 9:51 AM > *To:* [email protected] > *Subject:* [f-nsp] Port state blocking? > > > > This might be a silly question, but I can't get a port to come up on a > ServerIron. I enabled the interface and connected it properly to a > FES-X2402 switch, but the J-B16GC and the J-B2Gx ports just won't come up > and forward. The cards have worked in other configs, but I can't get > anything to come out of "blocking" mode. Here are the shows (any help > greatly appreciated): > > ServerIronGT E-1#sho run > !Building configuration... > !Current configuration : 378 bytes > ! > ver 11.0.00TD4 > ! > module 1 bi-0-port-wsm6-management-module > module 3 bi-jc-2-port-gig-module > module 4 bi-jc-16-port-gig-copper-module > ! > context default > ! > aaa authentication web-server default local > no enable aaa console > telnet server > username admin password ..... > snmp-server > ! > interface ethernet 4/9 > ip address 192.168.0.77 255.255.255.0 > ! > end > > ServerIronGT E-1#sho run > !Building configuration... > !Current configuration : 378 bytes > ! > ver 11.0.00TD4 > ! > module 1 bi-0-port-wsm6-management-module > module 3 bi-jc-2-port-gig-module > module 4 bi-jc-16-port-gig-copper-module > ! > context default > ! > aaa authentication web-server default local > no enable aaa console > telnet server > username admin password ..... > snmp-server > ! > interface ethernet 4/9 > ip address 192.168.0.77 255.255.255.0 > ! > end > > ServerIronGT E-1#sho mod > Module Status Ports Starting MAC > S1: B0GMR WSM6 Management Module, SYSIF 2 M6, ACTIV 0 > S2: > S3: J-BxG2 JetCore Gig Fiber Module, SYSIF OK 2 000c.dbb5.b640 > S4: J-BxGC16 JetCore Gig Copper Module, SY OK 16 000c.dbb5.b660 > ServerIronGT E-1#sho int e 4/9 > GigabitEthernet4/9 is down, line protocol is down > Hardware is GigabitEthernet, address is 000c.dbb5.b668 (bia > 000c.dbb5.b668) > Configured speed auto, actual unknown, configured duplex fdx, actual > unknown > Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING > STP configured to ON, priority is level0, flow control enabled > mirror disabled, monitor disabled > Not member of any active trunks > Not member of any configured trunks > No port name > Internet address is 192.168.0.77/24, MTU 1518 bytes, encapsulation > ethernet > 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization > 300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization > 991 packets input, 77378 bytes, 0 no buffer > Received 581 broadcasts, 410 multicasts, 0 unicasts > 0 input errors, 0 CRC, 0 frame, 0 ignored > 0 runts, 0 giants, DMA received 0 packets > 0 packets output, 0 bytes, 0 underruns > Transmitted 0 broadcasts, 0 multicasts, 0 unicasts > 0 output errors, 0 collisions, DMA transmitted 0 packets > ServerIronGT E-1# > > +++++ > > Thanks much, everyone. > > > > >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
