On Fri, Jan 7, 2011 at 7:27 PM, Joseph Hardeman <[email protected]>wrote:
> Hi Everyone, > > I am having a bit of an issue, I have gotten a pair of Cisco 6509's with > the SUP-720 engines. I am trying to configure link aggregation between one > of these to a BI4000 I have to test with before we put them into production > and connect them to our BI8000's and fight this problem then. I have been > searching and looking at the docs I have. The configuration I have on the > Cisco's allow them to talk over the port channels between each other with no > issues. > > I can setup the command "link-aggregation active" on port "ethe 1/5" with > no issues it takes the command, but when I go to add a test VLAN on to that > port I get the following error message: > > error - some ports are running LACP and can not be tagged ports. > > Here is the command I am running on the BI: > > test(config)#int e 1/5 > test(config-if-e1000-1/5)#link-aggregate configure key 10000 > test(config-if-e1000-1/5)#link-aggregate active > test(config-if-e1000-1/5)#exit > test(config)#vlan 14 > test(config-vlan-14)#tagged e 1/5 > error - some ports are running LACP and can not be tagged ports. > I run this very config on FESX648 to Catalyst and SuperX to Catalyst without any problems. Are you running ancient code? Scott
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
