Sorry for the confusion. I’m new to QEMU.
So… I created the image with the below command: qemu-img create dos.img 200M This is my command line to execute QEMU and mount the drives and emulate devices is below: qemu-system-i386 -m 16 -k en-us -rtc base=localtime -device cirrus-vga -fda FLOPPY.img -hda freedos.img -cdrom FD12CD.iso -boot order=d I have also tried to minimize the command to just: qemu-system-i386 -fda FLOPPY.img -had freedos.img -cdrom FD12CD.iso -boot order=d I believe the issue is that after it reboots from partitioning and formatting the C drive it no longer sees the CDROM when trying to access the source packages. I issues trying to list the directory on the D drive when I exit from the installer. From: Jon Brase <jon.br...@gmail.com> Sent: Tuesday, September 24, 2019 11:09 PM To: Discussion and general questions about FreeDOS. <freedos-user@lists.sourceforge.net> Subject: Re: [Freedos-user] Issue installing FreeDOS on Raspberry Pi 3 FreeDOS (x86 software) won't boot (natively) on the Raspberry Pi 3 (ARM hardware), so if you got as far as to be able to select "install to hard disk", you must be using an x86 emulator, and, indeed, your screenshot shows that you're using QEMU. To minimize confusion, you should lead with the information that you're using QEMU, and follow it up with the fact that you're on a non x86 platform, as there are differences in how QEMU handles guest code for the same architecture that it's running on and how it handles code for other architectures. I myself haven't run FreeDOS on any platform other than x86 PCs, so I'm not sure how much help I can be, but can you say what emulated peripherals you set up for your FreeDOS VM in QEMU? -------- Original message -------- From: shift83...@gmail.com <mailto:shift83...@gmail.com> Date: 9/24/2019 22:15 (GMT-06:00) To: freedos-user@lists.sourceforge.net <mailto:freedos-user@lists.sourceforge.net> Subject: [Freedos-user] Issue installing FreeDOS on Raspberry Pi 3 I have tried multiple times to install FreeDOS on Raspberry Pi3. I have created a 100M and 200M raw disk image. Mounted the Standard and then tried with the Legacy ISO. Both will boot the ISO, partition and format the hard disk. But when I reboot and select the Install to Harddisk after it goes to gathering settings a couple of minutes go by and I get: I have also tried to mount the floppy.img as well as the ISO and boot from floppy with the same results. Has anyone seen this and been able to resolve it? Thank you, Chris
_______________________________________________ Freedos-user mailing list Freedos-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/freedos-user
