Hi there, I ran the following analysis commands:
mri_cor2label --c /autofs/cluster/iaslab/NMASA/mri/recon/$s/mri/aparc.a2009s+aseg.mgz --id 11106 --l /autofs/cluster/iaslab/NMASA/mri/recon/$s/label/labl_ACC_lh.label funcroi-config -label labl_ACC_lh.label -analysis analysis_induc_block.lh -roi roiconfig_ACC_lh funcroi-table-sess -analysis analysis_induc_block.lh -contrast contrast_neg_V_neut -roi roiconfig_ACC_lh -sf sublist_All_SHORT_n111 -o sumtable_ACC_lh.dat After running the 'funcroi-table-sess’ command I got the following error: ERROR: There is a vertex in the label that cannot be matched to the surface. This usually occurs when the label and surface are from different subjects or hemispheres of the surface has been changed since the label was created. It seems that the problem might be that the command is using my participant (in this case, nmasa_001) as the source subject BUT it’s using fsaverage as the target subject. I want the target subject to be my participant as well (not fsaverage). Is there a way that I can specify the target subjects? Or is there a more efficient way do what I’m trying to do (ie: 1. generate labels for each participant based on their aparc+aseg file and 2. calculate the mean contrast signal from each ROI for each participant). Thanks, Keji --- Morenikeji Adebayo Clinical Research Coordinator Department of Psychiatric Neuroscience Massachusetts General Hospital (p) 617.643.6347 k...@nmr.mgh.harvard.edu
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.