You can pass it a --mul SCALE option to multiply the output by any
scaling factor
On 3/7/2023 1:16 PM, John Anderson wrote:
External Email - Use Caution
Dear Freesurfer community,
Please forgive me for the basic nature of my question.
I was wondering whether there is an argument that can be included in
mri_segstats to display the results in cubic centimeters (cm^3)
instead of cubic millimeters (mm^3). thanks for any suggestions.
Thank you, John
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.